/Nexus - 0506 - New Times Magazine/pages/0053/image.png)
Page Content (OCR)
NEWSCIENCENEWSCIENCENEWSCIENCE
At this stage, a few comments may be of become hot, as this will also deplete the
assistance about the type of water to use. I energy. The optimum level of energy is
would recommend a read of Callum Coats' absorbed at 4°C.
book, Living Energies (available from Unfortunately you will find that the
NEXUS), which is a great revelation about stainless steel milk separator cones are
the nature of water and its ability to memo- quite scarce if you wish to build the keg
rise and energise. Callum explains that the — cell, but auctions in country dairying areas
best-energised water comes from high are a good source.
mountain springs at 4°C. The blue waters Once the plates are conditioned, they can
of New Zealand's fast-flowing rivers may _ then be incorporated into the car cell and a
also be an excellent choice to begin with (if new set of tubes then set up for a pre-con-
you live in New Zealand). These waters ditioning cell for future use. Your car cell
will already be highly energised and rich in __ will need topping up from time to time or
minerals, giving a good current flow up to __ re-charging in the event of a discharge, so
5 amps. Another suggestion is to use one _ it is necessary to have a bench cell handy.
of the many water energisers now on the Whatever you do, don't use electrolytes
market prior to putting the water in the cell. or you will kill the energy of the cell.
Joe says he used his local creek water As the cell becomes aligned, you will
and even town water. We have no idea _ notice that the explosions from the bubbles
about the make-up of his water, but it | become more acute. The surface tension
would seem that once the plates of the cell _ will also increase, which allows big bub-
are conditioned it is easier to condition bles to form. When you light these bub-
ordinary water. bles, your eardrums should literally ring.
Joe's 'keg' cell is used to purify and con- Joe says that a light bulb above the cell
dition a quantity of water for the car cell, _ could even burst from the explosion. If this
but I would suggest using the glass cell as happens, your cell is ready to be installed
the purifying and pre-conditioning cell. As _ in the car.
the sludge forms on the surface, simply Readers may be interested to know that
overflow the cell so the sludge runs off the when Barry Hilton was experimenting with
surface to a catchment tray. Likewise, for his keg cell, he found that the water did not
settlement, pour off the clean water, wash _ pass through a large domestic strainer
out the cell and refill the cell with the same when he was skimming off the scum from
water or fresh water if necessary. This may the top of the water. The strainer had a
have to be done many times while condi- good half-inch of water in it, and the water
tioning the cell. Do not allow the cell to refused to pass through the mesh until the
underside of the mesh had been dipped in
water as well.
It's also been reported to me that lumi-
nescence or flashes of light have been seen
in the keg cell as the water became highly
charged.
Note that it is advisable to set up your
cells well away from intense electrical
fields as may be found in a workshop.
However, there have been reports that
when the cells have been set up and used
outside, they seemed to exhibit some
weather-modification effects. NEXUS
readers may be aware of Trevor James
Constable and his orgone weather-engi-
neering research. I welcome further feed-
back from outdoor experimenters.
One last point. When selecting your
stainless steel, don't forget to take along a
small neodymium magnet to test that the
steel has the least magnetic properties. The
less magnetism in the cell, the better the
chance of making it work. Machine your
tubes with precision and use a stainless
steel cleaning agent to bring them up nice
and shiny.
Do not allow electroplating of the plates
to occur due to high voltages, as this will
inhibit the functioning of the cell. Twelve
or 24 volts should do the job, but Joe does
use a Telecom charger which is around 60
volts. You may like to try the electropol-
ishing process as this will give a brilliant
finish to the tubes which may assist the
field alignment in the cell, as in a mag-
netron. However, this is our suggestion,
not Joe's.
I want to thank NEXUS readers on
behalf of Joe and the author, Barry Hilton,
for the great enthusiasm and interest shown
in this most amazing phenomenon. The
Earth is going through extraordinary
changes at present, and if we are to have
any future in the next millennium it is vital
to bring this technology to the fore. oo
WELL, YES, TRE
RE-ANIMATION
PERIMENT IS
A COMPLETE
Editor's Note:
For further details, contact lan of
NuTech 2000, PO Box 255, Ivanhoe,
Victoria 3079, Australia; telephone/fax
+61 (0)3 9457 2814; e-mail